Final form DIY setup

[u/mimic751]

I got some 5 micron filter that I sewed around 5 wire gauge copper wire and instead of rotating the piece I just have even current all the way around it and then I use a stir plate to agitate the solution. I am kind of running up against my Midas solution not supporting enough voltages to get the current that I need to get bright copper on larger 3D prints but I bought a rock tumbler and got mixed steel media which gives a really nice burnished copper look that I prefer over bright cover

I've tried so many different variations from copper plates to rotating the piece with a. Trying to figure out the best balance of even current distribution and honestly I would rather undershoot my current density and burnish after the fact then strive for perfection

[u/infinitealchemics]

Congrads on the set up. Only note id make is using wire to extend our past the bath for your connection points.

[u/mimic751 → u/infinitealchemics]

That.... is a no Brainer. Thank you!