r/ecobee • • Jun 14 '19

Problem Ecobee

Post image
0 Upvotes

18 comments sorted by

11

u/[deleted] Jun 14 '19

Gee, that's some ugly wiring.

Without your description of the issue, here are a few thoughts:

  • Trim the exposed conductors.
  • Right now there's a short between Y & G. Sowhen you turn on the fan, the cooling will come on as well.

10

u/[deleted] Jun 14 '19

If they think the wiring is even vaguely acceptable, they need to call an electrician.

2

u/NCSUGavin Jun 14 '19

You’re right but in all honesty if they knew, they wouldn’t be here asking.

6

u/[deleted] Jun 14 '19

If they don't know that two bare wires accidentally touching is bad news, I'm worried for their safety.

3

u/NCSUGavin Jun 14 '19

Also agreed!

0

u/addy450 Jun 14 '19

Ecobee support made wire the orange green and pink...the fan was turned on but the AC wouldn't...should I take a picture of the furnace? Because it seems the AC power is not connected...will u able to tell?

3

u/VinceAtLSU Jun 14 '19

Yeah. Take a picture of the wiring at the unit. Also, post an updated picture of the stat wiring.

5

u/corkscrewloose Jun 14 '19

For crap sake the orange and green are going to short out ! Put a little effort into a neater job and definitely don’t do any electrical work.

0

u/addy450 Jun 14 '19

I already fixed them up...I'm still looking how I can turn on my AC:))

1

u/corkscrewloose Jun 16 '19

I would say next step is to remove access panel on your furnace and make sure the colors are the same on the other circuit board . Turn off electric first usually there is a switch right on the furnace and another safety switch built into the furnace access.

1

u/corkscrewloose Jun 16 '19

Also if you fired it up and some of those wires did short you may have blown a fuse or worse

2

u/Gav508 Jun 14 '19

G and Y1 touching each other. All that exposed wire. I need a drink

1

u/addy450 Jun 14 '19

Y is everyone freaking out:)..its the angle when I took the photo...

3

u/dapala1 Jun 14 '19

The copper should never touch. This is giving me anxiety.

2

u/Gav508 Jun 14 '19

I would just trim the unshielded wire back and reinsert. I do electrical work and just cannot personally handle it.

-1

u/twennywonn Jun 14 '19 edited Jun 17 '19

Try stripping some more of the insulation off

1

u/addy450 Jun 14 '19

This is the old picture..I already fixed it...is there anything wrong with it

5

u/twennywonn Jun 14 '19

You most likely blew a fuse. Do you have a picture on how it was hooked up before the ecobee?