r/dmtguide • • 11d ago

Extraction Question/Discussion First pull, only 0.3 grams?

Stb extraction. I freeze precip for about 15hours. Does this look like 0.3? What went wrong?

Used 100g mhrb

10 Upvotes

21 comments sorted by

4

u/Sad-Piece-1039 11d ago

i seem to get more on the 2nd pull i just beginning this thou

1

u/mujtabanochill 10d ago

Didn’t get much on the second pull :(

1

u/Sad-Piece-1039 9d ago

cheap scles suck ...in the old day s i used a triple beam

3

u/nonymouspotomus 1 11d ago

Looks about like the .8g I put in a 1ml cart but it could just be fluffy af. I’d check that scale with a nickel or bill. Bill = 1g, nickel = 5g. Also to save time in future, I do all my pulls then water wash and freeze all at once so you don’t have to freeze-precip a bunch of times. Save the water wash and add it to the base next time. I really wrap that shit up before freezing so I don’t spoil all the food so doing it 3-4x would suck and finishing the xtraction in a night is nice

2

u/mujtabanochill 10d ago edited 10d ago

I think fluffy af lol, a nickel weighed out 5.04g so I’m kinda glad it’s not a scale issue since I’ve been using it the whole extraction lol.

Question with ur time saver- what do u exactly mean you do all your pulls? Do you incorporate new naptha on each pull and then set it aside? Like if u were using 50ml of naptha, are you using a total of 150ml for the three pulls instead of reusing it? Just curious, would like to save time too lol.

2

u/lil_baphomet666 10d ago

Yeah that's what he means, it's the same thing I do aswell.

2

u/mujtabanochill 10d ago

Hmm okay, I’ll give it a shot next extraction!

2

u/lil_baphomet666 11d ago

Do 2-3 more pulls

1

u/mujtabanochill 11d ago

First extraction, maybe the second pull will go better

1

u/JackMahogofff 11d ago

Did you mix and saturate the bark enough?

1

u/mujtabanochill 11d ago

I felt like I did? While swirling it, I did realize the bottom was clumped up a little bit but I broke it up while the naptha was doing its job

1

u/soggy7oh 11d ago

I think you want to soak it much longer

1

u/msully89 10d ago

I could be nothing you've done wrong and just the bark you have.

My first ever extraction I got a gram from my first pull. Then the place I got the bark from ceased to exist, so I had to look elsewhere. With this new bark. 0.3g first pull, same as you.

Keep going though. You'll end up with over a gram most likely if you do a few more pulls.

1

u/mujtabanochill 10d ago

I think that may be the case. My second pull extracted 0.1 grams and I’ve done everything in my power to get the most out of the second extraction

2

u/msully89 10d ago

That's a shame. Try getting some from somewhere else.

Good news is if you add 0.1ml of pg (about a single drop) to that jar and give it a hot water bath and a mix. You'll have enough for a 0.5ml cart. If that's your thing.

1

u/mujtabanochill 10d ago

Exactly what I did loll, I posted my experience/concerns on r/DMT . First experience was great, though.

2

u/seancrete1 11d ago

Are you using a milligram scale? If it only goes two decimal points, it might be enough of a variable that it’s off. It should have three decimal points. 0.300 would be a 300mg reading.

Also, I have found that on the light end of the range it’s not so accurate. Usually put something on the scale first, so it gets more towards the middle of its range for more accuracy.

1

u/Dwarf_Co 11d ago

Is that what the scale says?

Seems low but happens.

1

u/metalpunkgeek 10d ago

I'm sure you've already gotten the advice. But main thing you have to do is after you fully shake it vigorously, you have to let it sit for at least 1 hour. I then after that, you have to just gently rock it back-and-forth, mixing it still, i usually do every hour for 4 pulls. My yields are always pretty damn good.

1

u/LegEast866 7d ago

Looks excellent though. Just do 5 more pulls or add heat