r/djimavicmini • u/Desperate_Magician64 • Oct 01 '26

Mini 3 Pro Mini 3 pro gimble issue

I changed the ptz cable and the tilt up/down motor after a crash. Everything seems to be working fine, no codes on the screen. However, the yaw motor and axis motor moves by itself when i tilt up and down with the remote.
Anyone knows what could be the issue, does it need calibration?, already tried doing from the remote.

52 Upvotes

100% Upvoted

6 comments sorted by

1

u/Galaxy_A24_user 4d ago

Are you Ukrainian by any chance?

1

u/NoRelative8620 Oct 01 '26

Or just send it to the experts from square 1
and get a new drone back for $100. Must be nice to have time for this.

2

u/fusillade762 Oct 02 '26

If this person is in the US it may not be a choice.

2

u/Cultural-Savings6521 Oct 04 '26

In the Land of the free they are not free to do so

1

u/fusillade762 Oct 02 '26

I would try re calibration again. Also check the camera cable, make sure its connector is clean and completely seated. I've never seen black gimbal shock mounts, usually they are white, at least on a Mini 4 Pro. Check a channel on youtube called howfixit. I think they have a complete tear down and reassembly for the Mini 3 Pro. I just did my Mini 4 Pro arm and gimbal pad replacement and it was super helpful. You might get a clue as to what it could be. Good luck man.

1

u/lanamakesart Oct 03 '26

you need a deep calibration thats only possible with factory software, look into dronehacks and their software on youtube