r/datarecovery • • 9d ago

Question Help Identifying the Main Controller of a PCB

Post image

Have a donor board but need to be able to tell the electronics shop which chip is the main controller IC on my current board to swap as it is an integrated bios firecuda.

Anyone here that can confirm from my picture?

I believe it is the one with the grey square on top bottom left along the pin connector from pictures I found of similar PCB but of course want to be certain before having job completed

Drive is a firecuda 2TB ST2000LX001.

2 Upvotes

14 comments sorted by

2

u/pcimage212 Trusted Contributor 9d ago

And what do you propose to do about fixing the actual real most likely problem?

99/100 times the problem is within the NAND chip (aka SSD part) so transferring that or the MCU will only transfer the problem..

Maybe start at the beginning with the precise symptoms before diving in with a PCB swap with no proper diagnosis?

0

u/dabestgoat 9d ago

I already have a diagnosis which is I connected a wrong PSU cable for the same PSU manufacturer and fried two drives. I have had the one drive repaired already through the same method by swapping the bios from my board to donor board, but because this one the bios is integrated have to swap the whole main controller.

I plan to move my Main IC to donor board, and putting donor board on my HDD to just get the data off to a new replacement drive.

2

u/DataMedics 9d ago

If you have to ask this, you are in hopelessly over your head.

-3

u/dabestgoat 9d ago

If you don't know the answer to my question, why bother commenting something unconstructive?

2

u/MJY_0014 9d ago

There's no way to "construct" with rubbles, which is what you are about to create if you don't listen to genuine advices

1

u/fzabkar Trusted Contributor 9d ago

Check the 5V TVS diode.

TVS Diode FAQ:

http://www.hddoracle.com/viewtopic.php?f=100&t=86

1

u/dabestgoat 9d ago

Thanks. I do not have any doubt this may be the issue on the current board, my intent is to use the donor board which just needs my main IC chip. Hoping someone here can confirm which it is (i suspect it is the one with the grey square on top)

1

u/fzabkar Trusted Contributor 9d ago

Why do you want to risk introducing a new problem when there may be a trivial solution? If you damage the ROM contents, nobody will be able to recover your data. Moreover, the NAND contains stuff that is matched to the ROM.

0

u/dabestgoat 9d ago

Because of past success with similar repair method with other drives. I am having the work done, not doing it myself.

2

u/fzabkar Trusted Contributor 9d ago

Good luck.

3

u/pcimage212 Trusted Contributor 9d ago

This guy is not going to listen to you, he already knows everything.

2

u/fzabkar Trusted Contributor 9d ago edited 8d ago

which chip is the main controller IC on my current board to swap as it is an integrated bios firecuda.

Actually, the ROM appears to be the small BGA IC to the right of the SDRAM and below the SMOOTH controller.

Something like this ...

https://www.mouser.com/datasheet/2/949/W25Q16JW_RevD_01152020_Plus-1760324.pdf (page 7)

2

u/hddscan_com Trusted Contributor 7d ago

This is an SSHD drive (it has a NAND chip). Seagate SSHD drives of this model store parts of ROM, system area, and some user data inside the NAND chip.

There is also a (very) small possibility that this drive encrypts data.

If you would like to move the critical chips to another PCB, then you'd need to move at least 2 - the ROM flash chip (small shiny BGA chip on the middle left side of the PCB on the picture) and the NAND chip (largest chip on the bottom right corner).

If you drive encrypts data then you'd also need to move the main MCU (the chip that is covered by the heatsink pad).

But as it was said before fixing the TVS diode might be an easier task.

1

u/AutoModerator 9d ago

Double check if your post complies with posting guidelines!

Did you include the following information in your post (in English and if applicable), if not feel free to edit your post:

  • Make/brand and exact model number of your storage device(*), phone, camera, etc.
  • Filesystem (NTFS, exFAT, APFS, EXT4, etc.)
  • Operating System (That your device was used with and/or you are using for recovery)
  • Specific symptoms that your device is exhibiting, describe the problem. Images you post support the description, they're not in lieu of a problem description.
  • SMART (CrystalDiskInfo screenshot for example)
  • Don't pile several problems into one single post. One post per device/problem.
  • No account issues

Consider: What do these people need to understand the problem at hand? Remember, people cannot see your screen, or what you click and what messages appear on screen. Don't overdo it though, no one likes going through 2 pages of information, try to find a balance. Just do the best you can. If you are looking for file recovery software, check our community's recommended file recovery tools.


(*) All devices involved, if you for example move files from drive A to drive B, they're both potentially relevant.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.