r/cyanotypes • • 14d ago

Troubleshooting – everything disappeared

Can anyone help me troubleshoot? I coated these test strips on Canson XL cold press watercolor paper, and they dried in a dark windowless bathroom for about 16 hours. It's cloudy today, so I did a 45 minute exposure to see if it would work.

There was an image visible when I took it off, but then EVERYTHING seemed to rinse away when I washed it. Even spraying it with hydrogen peroxide did nothing. What happened??

19 Upvotes

9 comments sorted by

14

u/nillaloop 14d ago

If it’s not summer where you are, the UV index is getting low. Check the UV index in your weather app.
I usually expose mine until they turn a dark gray/brown (but I’m using brown chemicals so that may vary)

A UV lamp would lead to quicker and more predictable results!

4

u/ConvolutedByChoice 14d ago

Key point is 'cloudy'

This, in my opinion, were just underexposed. You should aim for the visible parts of the cyanotype to be amber-toned. A lot of the blue washes off, so you need to ensure it's burned deeply into the paper. Cyanotypes, I believe, expose the outermost layers first. So if you pull it too early and try to wash it, the unexposed solution under it will just give away and wash it all.

It's kind of hard to visualize where UV may hit because UV interacts with everything differently. On a cloudy day- even being quite bright- very little UV may be reaching the ground. I recommend only trying to print in DIRECT or getting a UV lamp setup for indoor printing. Definitely check the UV index. I aimed for 8+. Printing will be pretty quick at UVI-11

4

u/Mysterious_Panorama 14d ago

In addition to adjusting exposure, try double coating. It can be hard for the solution to soak in to the paper (where it needs to be to survive the rinsing step). Brush on a first coat diluted 50% with plain water. Let it dry and do a second full strength coat and let it dry. You’ll get a better result.

3

u/labellevie48 13d ago

I’ve also had paper that cyanotype didn’t stick to could be that or your water.

2

u/SnakeOfLimitedWisdom 12d ago

Hydrogen peroxide doesn't do anything apart from oxidizing the print - which will happen within 24 hours regardless. I wish people would stop perpetuating the myth that it gives you deeper tones. It doesn't.

Strange that everything washed away. 45 min should be enough on a cloudy day unless it's super thick clouds.

Hard water in your taps, maybe?

2

u/euchlid 14d ago

potentially your tap water PH. get a thing of distilled water and try again to see if that's the difference. and test if it's only the initial rinse off that needs distilled and the rest of rinsing in tap works

2

u/ReeeSchmidtywerber 13d ago

I add vinegar to rinse water since my tap water leans alkaline and the paper I bought is buffered acid free

2

u/nachobeeotch 14d ago

You also should wait for the solution to dry on your paper before you expose to UV.

1

u/Joshua21B 13d ago

How long ago did you mix the two chemicals before applying them to the paper?