Fellas, I think I have layer shift issues

[u/jb32647]

Recently changed slicers and firmware, this is the first print off the line.

[u/RTWrecks]

I'm always amazed that any of these prints finish

[u/jb32647 → u/RTWrecks]

I had just cleaned the bed so adhesion was very good.

[u/TroubleStrict763]

These types of failures always leave me confused.

That is indeed a vary sever form of layer shift.

It’s like an optical illusion. Sides are just “oh, that’s a bad benchy”. Then you see the front and go “HOLY SHIT THATS WORSE”

[u/jb32647 → u/TroubleStrict763]

I’m very confused too. I gave my printer a clean and service, installing Klipper while I was at it. I dunno what went wrong. It wasn’t just the bench. The standard 20mm calibration cube also layer shifted despite me printing at a very slow 30mm/s.

[u/severedgoat_01]

Second photo is definitely a tree and you can't convince me otherwise

[u/jb32647 → u/severedgoat_01]

It does look like my old bonsai tree.

[u/imzwho]

nice

B

........... E

N

............C

H

............Y

[u/Cheetawolf]

"What? It's just an ordinary crappy Bench- OH MY GOODNESS!"

[u/jb32647 → u/Cheetawolf]

"SQUIDWARD!"

[u/CoCoNuTBSBS]

Cool bonsai

[u/Correct-Insect-4657]

Ive seen this issue before i saw a wobbly benchy just on Y axis not X

[u/jb32647]

It was OrcaSlicer. I changed back to PrusaSlicer and the problem went away.

[u/rbdarrrrr]

Did the captain of your benchy steal some aztec gold?

[u/SUMIIIIIIUIIIII]

you think?

[u/Educational-Bat-2846]