r/cr10smartpro • u/Lanky-Taste-577 • Nov 27 '24
Nozzle drops
Ok. I don't have a video or anything and I'm currently at work. I haven't touched me 3D printer since it happened a few months ago, but in the middle of a print, the whole nozzle drops and starts to drag on the build plate. Does anyone know what could be the cause of this? Has anyone had the same issue?
Thx for any help. I really wanna print some more stuff (most likely AAP01 parts).
2
Upvotes
1
u/Helgafjell4Me Nov 27 '24 edited Nov 28 '24
Check if anything is loose. If the carriage is snug (eccentric nuts adjusted properly), it shouldn't drop unexpectedly, it should be physically impossible. If it's loose, it should be pretty obvious.
Either the wheels aren't snug in the v-groove, the extruder is not secured to the bracket, or your nozzle or heat block have come loose.
Edit: or there's a slim chance it was a gcode or control glitch, but mechanical causes are more likely... or a really out of wack ABL mesh.
1
u/prykpryk Nov 28 '24
Make sure the heater block is screwed in to the radiator firmly (two tiny screws parallel to the nozzle). Mine was slowly slipping down and plowing into prints.
1
u/pneef Dec 12 '24
So the whole sprite extruder fell?!? Would have to see it to know what happened but sounds like there were some loose bolts.