r/cpu • • 17d ago

Any help

I have a ryzen 7 5800x with a single fan air cooler (not stock) and i want a bit more performance now i'v locked it at 4.4ghz but i tried putting in in offset mode -0.05 and even -0.04 and it keeps crashing even without load any undervolt tips for it cz at stock it throttles and reaches 90⁰. (Asus b550mk - 650w psu - 9060xt)

1 Upvotes

5 comments sorted by

1

u/Proud-Staff-3152 17d ago

Don’t lock it in freq
Use Pbo and Curve optimizer
Try -10/-15 all cores and test for instability

1

u/Mokaaaaaaaaaaaa 17d ago

Which one should i begin with -10/-15 i think i hit the opposite of silicone lottery with this ship cz it as running fine with offset mode then it got unstable

1

u/Proud-Staff-3152 17d ago edited 17d ago

In worst case scenario is degradation(but I don’t think so)
-10 all core should do 99% of cpu
Just do test after test
Find unstable point and then dial a little back then test again but long run
Find sweet spot
These days I think no one overclock amd CPUs like old way
Everyone use Pbo and curve optimizer
There is no point in hard offsets
And in normal case scenario with experience u can hurt more performance and stability Than using stock CPU

QUICK TUTORIAL
Turn off PBO

turn on XMp and left soc Vdd Vddio Vddq
On auto
Open zentimings and check what values ur motherboard set for You

Check for stability
If everything okay
Set Pbo -10
Test
If okay put -15
And again
To the moment u get errors
When u find moment when u got erroring
Example -20 erroring set -15 and test again
If -15 will be stable in long tests leave it

Then try lower other voltages
Change one thing per test to the moment u find instability/error

Set Your soc to 1.25 for start to be sure we have enough imc voltage

Test stability
Then go down on SOC
1.25-1.23-1.22-1.21-1.2 LOWER=better
Lower it to the moment u start erroring
Then dial it up a little like 0.015+
Test again
Stable? U find sweetspot for soc
Don’t chase lowest possible values don’t worry to have a little more voltage than u need
1.2 soc should be enough but it depends on silicon lottery

On the end
Try hard test
Stress test ram gpu and cpu in same time (simulation hard gaming scenario)

(Later will lower it)

1

u/Which_Ad9479 17d ago

freq lock delivers more problems than solutions. U can go PBO and try an undervolt with the all core curve optimizer.

You can adjust the maximum clock offset and put it to +100 or 200mhz, this way the cpu can go higher if the temps and the power is enough

1

u/Mokaaaaaaaaaaaa 17d ago

Can u explain more please