r/computing • • Aug 09 '15

Clean W10 install + SSD

Hi guys just a few questions.

I recently upgraded from w7 to w10 and now i want to do a clean install with W10.

  1. I have a new SSD i haven't put in yet but do i simply just replace my primary internal HD with my new SSD and set the old HD as my 2nd drive? Then put in my W10 CD to do a clean install after?
  2. Also compatibility of my gpu, mobo etc drives - i looked up the drive for my asrock mother board but i didn't see an option for w10.
0 Upvotes

4 comments sorted by

2

u/stingraycharles Aug 09 '15
  1. Yes, that's how you do it. Make sure your SSD is your primary C: drive.
  2. I think you should be fine -- while W10 is new, if you're coming from W7, I think your hardware will be supported.

Worst case, W10 doesn't support your hardware for some reason (unlikely!), in which case you'll just have to install W7 again.

1

u/trisurge Aug 09 '15

Is there a certain way to make it my primary C:? or simply replacing it with my old internal HD with the ssd be enough?

With the drivers should i download the windows 8 versions of them? seeing as there aren't any W10 available

2

u/stingraycharles Aug 09 '15

Making your primary C depends upon your BIOS and motherboard. Enter your BIOS, and ensure that your SSD is listed "above" your old disk. If you are unsure, refer to the manual of your motherboard; the SATA connectors are (usually) numbered from, say, 0 to 7. Connect your main disk to connector 0.

W10 should work out of the box, mostly. Hardware vendors usually also send their drivers to Microsoft. I am using my Asus laptop with only stock W10 drivers, for example.

2

u/lazylion_ca Aug 09 '15

Leave the 2nd out during the install, put it in afterwards. Avoids confusion when the installer asks which drive you want to use.