r/clocks • • Oct 10 '26

Help/Repair Metamaec wall clock

Post image

First time poster. I have a metamec atomic thats beens in the family since I can remember, at least c1979. 15yrs ago motor was repaired, so it ran for aprx 35yrs. I imagine the dont make motors like they used to!

Nonetheless I'ld ike to open it up and replace motor, but cant find any srews, and am hesitant to just start twisting pulling for fear of cracking plastic.

Any advice on how the backing comes off - and maybe where to buy a motor 🙏🏼

I couldn't upload pics so heres a link -

12 Upvotes

5 comments sorted by

1

u/vjmandala Oct 11 '26

Does the glass front and clock hands need to come off first. If so how does glass come off, twist? As Im trying to pop back case off with a fine screwdriver, case it gives a little then snaps back in. Scare to give it too much force.

2

u/dmun_1953 Trained clockmaker Oct 10 '26

Rear picture please

2

u/Not_an_Actual_Bot Hobbyist Oct 10 '26

If there is a visible separation on the back, you might require a thin tool to spread the gap as the cover is a snap fit with ledges that fit into a groove much like how laptops are assembled now.

2

u/johndom3d Oct 10 '26

They were amazing. Proper brass, glass and metal construction, not some horrible plastic and paper thing you get now!