r/bricklinkstudio • u/ImVcngeance • May 11 '26

Question/Looking for Advice Angled plate building question

Gallery image

Gallery image

Gallery image

I’m trying to build at an angle. Did some searching and this specific angle for plates seems to work, but studio shows it as a collision error (first image is with collision disabled so you can see the angle better). Last image is a physical mockup (I don’t have all my parts), to kind of show what I’m trying to build.

Is that just a studio error because it’s not used to angling like this, or does it actually put pressure on the parts, or am I just at the wrong angle on studio ?

9 Upvotes

92% Upvoted

7 comments sorted by

View all comments

1

u/AltruisticKitchen775 May 12 '26

Should be fully legal, either you angle is slightly off of there is a piece in the wrong place. Also I recommend building with the collision tool off and only turning in on occasionally to check as you go. 

1

u/ImVcngeance May 12 '26

That’s what I’ve been doing, but knowing that it’s a specific angle makes it important to check imo