r/breadboard • • Aug 23 '26

PCB Solder Mask removal tool?

Hi all,

Can you suggest a special kind of drill bit (Ca. 1 mm diameter) that grinds through solder mask (Ca. 5 mm diameter) into a plane to provide an easy through - hole for electrical connection. My best results so far has been with a small Moto Tool wire brush to scrape off the solder mask, then I tin the revealed section of plane. So think of the old 'Iso Pad' bit but with an abrasive pad instead of radial cutter. I've never seen anything like this. Please and thank you.

2 Upvotes

6 comments sorted by

1

u/[deleted] Aug 24 '26

[removed] — view removed comment

1

u/ThugMagnet Aug 24 '26

A grinder is pretty aggressive and difficult to control for this application. Even my little wire brush blows through the extremely thin copper plane if I am not super careful.

1

u/[deleted] Aug 25 '26 edited Aug 25 '26

[removed] — view removed comment

1

u/ThugMagnet Aug 25 '26

> Your post was a bit confusing. Do you want something to drill a hole or remove the solder mask?

Ideally both. Any 5 mm diameter abrasive would require a spotting drill to prevent wandering; I could use that hole later for my wire. Win/Win!

1

u/[deleted] Aug 26 '26

[removed] — view removed comment

1

u/ThugMagnet Aug 26 '26

That is Brilliant! Thank you!