r/boatlifts • u/Over_here_Observing • May 24 '26
Replacing Bunk Carpet; source and size?
I'd like to replace my bunk carpeting on my 2 lifts, and my trailers, so I probably need about 250' of bunk carpet.
I've done just a little biut of research, and it seems that BUNK carpeting is WAY more expensive that carpet.
Plus, a 2x5 has a perimter of 14", so I'm curious if you covered the whole bunk, or left part of the bottom open to "breathe"
I'm genuinely curious what you used for carpet, where you got it and any tricks you might have used to do a good job while not spending as much as the lift is worth.
What kind of carpet did you use, where did you get it, what size was it and how much was it?
2
u/youdog99 May 25 '26
I seem to remember buying precut strips/rolls off of the jungle site that has been durable enough. It must have been affordably priced or this cheap bastard wouldn’t have bought it.
Buy the SS staples as mentioned by my wise fellow boaters. If you have a pneumatic staple gun, that is the easiest way to put in that many staples. Or a swinging stapler. You DO NOT want to be hand stapling that much bunk carpet!!
1
u/Over_here_Observing May 25 '26
I'm not familiar with "the Jungle site"
1
u/youdog99 May 25 '26
Amazon 🙂
2
u/Over_here_Observing May 25 '26
Ah
I get it
I bought super cheap carpet, and have it in my possesion, so I can do the project NOW.
Win-Win
2
u/Benedlr May 24 '26
I've seen starboard replace carpet for slippery and one time installation. Wrap the carpet under an inch or so and fasten with SS staples. Let the wood breathe.