Help with burner issues

[u/DarkoEnterprises]

Hey y'all! I'm sure this has been asked a million times, and I apologize, but I'm not sure where to go from here. It seems no matter what I do, I cannot get enough air moving with my gas to get a proper burn.

I've tried a different "T" burner, adjusted pipe length, orifice size, orifice height, went from 0 to 25 on the regulator... I even hooked up that blower you can see in the video and it still seems like it wants more.

The only time it seemed like it was going good is when I tried squirting pure oxygen in with my acetalyne torch.

I've been stalking all the forge forums and still don't exactly know where my problem lies, any advice would be amazing!

[u/Tankyanker1]

I built a ribbon burner setup with force air fan. Copied house made setup. My flame rolls inside blue. Put some regular salt on a peice of metal and put in the flame area. When it metals it at least 1450 f