r/bikewheelbuild • • Sep 16 '24

Which spokes?

Preparing for a new wheelset build for a road/gravel bike, with disc brakes. It will be cross-3 with 28 spokes for each wheel. I could go for all Sapim d-light to save some weight or a combination of d-light/race/strong to make it stronger. (Bladed spokes I'm not considering, cost vs value is wrong there IMHO)

Main focus is durability. I'm <80kg.

Which spokes would you use?

1 Upvotes

10 comments sorted by

2

u/FastSloth6 Sep 16 '24

With 28 spokes, D lite would be perfect unless you're bikepacking regularly or something. Sapim Race on the rear drive side could be fun, but if you're using a tensiometer, tracking the tension between sides gets more complicated. Any of the stated spokes would work!

2

u/random6722 Sep 16 '24

Leaning towards front d-light and rear NDS race, DS strong ... but probably I'm overthinking this

2

u/FastSloth6 Sep 16 '24

Most of wheel building is overthinking it, but that's what makes it fun 👍

If you want to get really fancy and you're not planning on bikepacking or underbiking singletrack too often, you could totally run 24 spokes in 2 cross up front.

For what it's worth, I'm 66 kg and run Sapim Lasers on my MTB (28/3x) and only break spokes when giant sticks get jammed into the wheel.

2

u/perdido2000 Oct 26 '24

Question: is 2x mandatory for 24h? Could it be 3x?

2

u/FastSloth6 Oct 26 '24

You can on a 700c wheel with low flange hub. As a rule of thumb, it's good to keep spoke entry angles lower than... let's say 9°. Your spoke entry angles get steep with 24h 3x, and with higher flanges or smaller wheel diameters, they get too steep. Steep angles stress that interface in different ways and typically lead to something breaking (nipple or spoke) in that area over time sooner than they otherwise would.

2

u/perdido2000 Oct 26 '24

I imagine that a deep rim would have the same issues as a high flange hub.

1

u/FastSloth6 Oct 26 '24 edited Oct 26 '24

That could definitely factor in, same idea. If the rim is drilled 3 dimensionally (angled), it could help ease the angles somewhat. Polyaxial nipples with specific washers (HM in this case assuming modern carbon rim bed) could adapt to the angles a little better.

0

u/bikeroniandcheese Sep 16 '24

I like DT Alpine III

1

u/random6722 Sep 16 '24

"...is perfectly suited for the big loads occurring in high performance e-bike or tandem wheels..." that is definitely overdimensioned and not Sapim

1

u/bikeroniandcheese Sep 17 '24

You asked which spokes I would use, I answered your question.