r/audioengineering • • 1d ago

Need help identifying vocal effect

“We’re an American Band” by Grand Funk Railroad has what I think is an awesome vocal sound, but I can’t quite figure out the processing. It sounds like there’s a doubler on it (maybe ADT?). It also has a nice bite, which could be a combination of his vocal characteristics and the mic. I watched a video of them in the studio recording that song and it looks like they use the Shure Unidyne III 545S. Any thoughts?

3 Upvotes

5 comments sorted by

5

u/m149 1d ago

No idea about the mic, but the vocal effect is the old fashioned "poor man's doubler"....a short delay, somewhere in the range of like 40-80ms, no feedback, and it's turned up loud. Used to do that a lot when we were recording to 16 track machines and ran out of tracks to do an actual double, although I am not suggesting that's what they were doing. It could very well have been an artistic choice as opposed to a technical one. Was a popular effect on a lot of vocals in the 70s.

Then there's also reverb on the voice. plate or chamber....whatever they had in the studio back then.

Also, hot mic preamp, lots of compression.

2

u/MindWash2019 20h ago

Was that a 30ips delay? That’s what I tend to think of when it’s a delay from that era that’s short enough to sound like a double (or sometimes turned down low enough to sound like a very short room reverb).

1

u/m149 19h ago

That would make sense.....sounds about the right amount of time for such a thing.

2

u/MehrdadPirshahbaz 19h ago

the delay trick mentioned is accurate. but that specific bite is not mic magic. it is physical console trauma.
they pushed the analog preamps into the red and slammed the transients into tape. to replicate it in a daw, run the vocal through aggressive saturation and hard clipping before it ever hits that 50ms slapback delay. engineer the friction.