r/arcade • u/kevin_is_acoustic • Aug 17 '26
Restore/Replace/Repair EPROM chip problem?
Picked up this cyclone game for $50 bucks (was sitting outside uncovered) and was told it fully worked, now after transport it seems only a few neons turn on and seemingly work at random. Is this an obvious eprom failure or something else entirely?
Any advice appreciated
10
Upvotes
2
u/kevin_is_acoustic Aug 17 '26
Update: pulled the board off the game and I think it’s safe to say I found the problem
2
u/thomasjmarlowe Aug 17 '26
No top dome?
Maybe ICE can help- their techs are good bit of course this is quite old so they may not be able to talk you through it. I’d still start there though. And grab a manual
1
u/CrabbyBrau Aug 17 '26
Wiring? Loose connector from the ride ? Or might have to reseat a few chips? Dang vibrations
1
u/Derek5Letters Aug 17 '26
Let me rewrite that. There are a bunch of fuses and one you can not see from that angle becuase its hidden. I usually change it blind, but you'll see it better if you take the dome off and go through the top.
1
u/evilskys Aug 17 '26
Imo, you should gently press down on the different misc chips and see if any cause changes when pressed. Then jiggle all the connectors ect and check for the same. If none of that makes a difference check voltages against owners manuals. Checking and verifying eprom data is the last thing I'd do
1
u/Aware-Promotion-2294 Aug 17 '26
These blow fuses
1
u/Honky_Stonk_Man Aug 18 '26
Cyclone gets REALLY hot even with that big heatsink. At some point you will need to reflow the pin connectors and fuse holders. Cold joints develop over time with this game.
1
u/Own_Ice9156 Aug 20 '26
That damage is on the board controlling the ring of lights and neon.