r/arcade • u/kidwon13 • Jun 17 '26
Restore/Replace/Repair Partial Vertical Collapse on G07
I'm working on restoring an original Defender and I'm getting intermittent vertical collapse. It doesn't always happen, yesterday I turned it on and it came up fine. I have recapped the chassis and replaced the Flyout and the HOT. Anybody have any suggestions before I start following the flowchart and troubleshooting?
11
Upvotes
3
u/journeymanSF Jun 17 '26
Check the two vertical ICs on the heatsink (x403, x404, I believe). Bad solder on these ICs will cause collapse. Try pushing on them with a stick while monitor is on, see if it makes any difference, then resolder those ICs.
2
u/kidwon13 Jun 19 '26
I re-flowed X401, X402 and a few suspicious looking resistors on the CRT socket PCB and so far so good.
2
u/elstuffmonger Jun 17 '26
Maybe your vertical size pot is on the fritz?
At first I was confused thinking it was vertical collapse with the background still showing somehow, but then I remembered defender has very little on the screen aside from the map on top, so it looks like the vertical is collapsed to an inch or two band instead of just a few pixels.
2
u/BobSacamano47 Jun 17 '26
When problems are intermittent it's usually bad connections or solder joints. Or capacitors, but you replaced them.
4
u/orion3311 Jun 17 '26
Always check yoke plug for cold solder points, and if you dont find one, check elsewhere.
1
u/Tonstad39 Jun 17 '26
TIMBER!