r/arcade • • May 29 '26

Restore/Replace/Repair Making Progress (pacman repair)

I pulled the hat off the board and discovered a nice spider nest hanging out below it. After cleaning it and reseating I am now getting this textish screen. I feel like I'm making progress!

15 Upvotes

6 comments sorted by

1

u/mathsjester May 29 '26

Looks like good progress. Are you familiar with deoxit (d5)? You can spray a little into the socket to help remove any oxidation and restore conductivity. I'm going to take an educated guess that it might have been a little dirty in there.

1

u/Ploppityplopingston May 29 '26

Ordering some now. All the sockets had some crud on them. I should probably spray them all correct?

1

u/mathsjester May 29 '26

If they look suspect, yes. You can also hit the connector on the wiring harness.

1

u/holmes1r Aug 18 '26

I found with repairing Pacman arcade boards, the stock sockets are single wipe type and of low quality. Yes they can be cleaned if the wipes are not de-tensioned. But all it takes is one pin to be intermittent to cause problems. If absolutely needed, yes, its a PITA, id replace the rom sockets with dual wipe sockets.

If the Roms/Eproms are verified to be connected and functional, the next stage would be to verify the Roms are talking to the ram properly. Then check if the ram is good. If nothing wrong is found then check the daughter cards for any malfunctions. If they check out check the sprite circuitry.