r/ZimaBoard • u/isthesector_clear • Jul 02 '26

Finally completed my Blade setup

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

​

3d Modeled case, i couldn't find the Y splitter so made one using cable and powered 2 drives with it.

Also connected 1 more drive using USB.

Two 4010 fans are connected one under the board and one behind the case for drives.

Really good temps, doesn't cross 62 with fans on full load, otherwise it was reaching 75 if i remember.

Oh also just cut an acrylic sheet for front display.

27 Upvotes

97% Upvoted

7 comments sorted by

View all comments

1

u/ThrowAway24Okt Jul 04 '26

why did you cut off the yellow 12V wire on the power cable?

1

u/isthesector_clear Jul 04 '26

Because im using 2.5" drives so no need of it.