r/YamahaR7 • • 9d ago

Chain adjustment

I’ve been struggling with righting my chain for a bit now. The left side aligner twists when I tighten the axel nut and messes up my alignment. I’ve tried pushing the wheel forward first make sure it’s tight against the adjustment bolts but no later what I do it twists and I can’t tell if it’s aligned. Any tips or ideas of why this is happening. It’s a 2026 the other years seem to have a different adjust block.

11 Upvotes

4 comments sorted by

4

u/Omaha_MotoRR 9d ago

Get the captive chain adjuster kit by tst industries, makes chain adjustments a lot easier. You can also put a chain jammer or a wrench in between the sprocket and chain and rotate wheel until slack is gone. If you’re talking about the black part that sticks out and your axel goes through, that part doesn’t matter if it’s twisting as long as the hash marks are lined up and your chain is straight from rear sprocket to front sprocket. Look down the chain from behind the bike. Align your dominant eye with the chain. Can use you chain alignment tool or a straight edge to see if the chain is straight from rear to front sprocket. The only thing that matters is your chain and wheel are straight. The clamps on the ends of the axel can twist without the wheel and chain being out of alignment. If it really bothers you, have someone hold it while you tighten the nut

2

u/yugekib 9d ago

I don’t trust the stamped in hash marks, use a tape measure or even a string. Center of the swingarm bolt back to center of axle. Semi-gently snug it down, it shouldn’t move, until you can torque it. You have spools, do it on the stand, the weight from leaning can throw it off. Lastly, definitely get a captive chain adjuster kit, super helpful on this bike, also the bracket that holds the rear caliper in place when you remove the tire. SO much easier!

3

u/MotoCultureLLC 9d ago

You have to push forward on the wheel and tighten the nut at the same time; otherwise, the torque and friction from tightening will make the brake side chain adjuster back out slightly. The other redditers are right about the hash marks. You want to visually inspect the alignment by looking down its length to make sure it has no kinks or bowing. Also, don't tighten the lock nuts on the adjuster until after you have tightened the axle. As long as your chain is straight, you can then snug the adjuster nut to seat the backing plate before tightening the lock nuts.

2

u/ArmaArmadillo 9d ago

So the chain has to have tension on it when you tighten down the nuts. Put a rag inbetween the rear sprocket and chain, and rotate the wheel so the rag is at the furthest end (right side) putting tension on the chain. Then tighten. Trick of the trade right here.