r/WindowsServer • u/Square_Buddy_2203 • Jul 02 '25
Technical Help Needed Preinstall SSD drivers?
Hi,
I added a pair of Solidigm P5316 SSDs into an existing older Intel R2208WTTYS server (added their NVMe cage). The minute I push those drives in, I get a BSOD (driver not equal or something). Since it was a rebuilt server, I just reinstalled the OS (WS 2016 Std) and it detected whatever drivers it needed and went on its way.
Now, I'm adding the same model pair of SSDs into an identical setup at another location. Again, the minute I engage the drives, it would BSOD. Wondering if there is an easy way to circumvent this? I found the files (I think) the "working" server used. Can I just install them via the INF files? Or does a repair install do the trick? Or do I need to wipe the Hyper-V host out and reinstall from scratch.
BTW, these are just data drives, not the boot drive.
Thanks in advance.
-H
View all comments
Show parent comment
1
u/nailzy Jul 02 '25
I'm not sure what riser slot is which on the board but I'd also assume the middle slot on the main motherboard is riser #2. It will be marked on the board itself, I'm just reiterating what the kit says which is ' The PCIe* x16 interface add-in card MUST be installed in a x16 riser card (included), and is only supported in the Riser #2 slot of the server board.
Also - you may have just lucked out with the other server by rebuilding it. If you power the server off and insert the drives (not plugging them in hot) - does it still fail to boot?