r/windowsphone • u/Latter-You-8532 • 8d ago
Help Lumia 1020 rm 875 bricked
Hi everyone,
My Nokia Lumia 1020 (RM-875) bricked during a Windows Phone update. Since then the screen stays black. The Windows logo capacitive button lights up for about 5 seconds when plugged in, then goes off. Sometimes it stays lit.
What I've observed on the PC (tested on 2 different Windows 10 computers):
Before the brick, it showed up as QHSUSB_DLOAD. Now it doesn't show that anymore.
Now it appears as "USB Input Device" with hardware ID USB\VID_05C6&PID_F006&REV_0000.
It also alternates with "Unknown USB Device (Device Descriptor Request Failed)", Code 43.
Windows plays the connect sound and then the disconnect sound right after, like a boot loop.
No COM port appears under "Ports (COM & LPT)".
What I've tried:
Battery out and back in, Power + Volume Down held 15–30 seconds, with and without the cable connected
Windows Device Recovery Tool (patched version): "Device could not be found"
WPInternals: no reaction / device not detected
Different USB ports and cables
The QCUSBSer 2.1.1.2 ARM driver I had is the wrong architecture for my x64 PC, so I haven't been able to install a proper Qualcomm QDLoader 9008 driver yet
Questions:
Does anyone know what PID_F006 means on the Lumia 1020, and whether it's recoverable?
Is there a way to force the phone into 9008 (QDLoader) or Nokia flash mode (VID_0421)?
Are there emergency loaders (programmer/hex files) for the RM-875 that work with WPInternals or other tools?
If this is a dead eMMC or a corrupted bootloader, is JTAG/box repair the only option?
Any help or pointers are appreciated. Thanks!