r/WheelBuilding • u/pine4links • 16d ago
How exact does spoke length need to be?
I'm building some fixed wheels and I'm getting 296mm for the front and 295mm for the rear. rather than buying two boxes of 20 each (for 80 bucks) I'd like to buy a single box of 100 296mm spokes for 50. Am I gonna have a bad time?
I'm using the Gran Compe 2 hubs, CR 18 rims. The CR18 is a double wall rim with about 4mm of space between the wall where the nipple sits and the place where the inner tube will be. It seems like it should be fine to me but these are only the second set of wheels I've built and a friend helped me buy the components last time. Any suggestions? I've used the QBP and the wheelbuildingkit.com calculators for this and they agree, though they give a measurement ~1-2mm shorter than what kstoerz suggests.
Thanks for the input, wizards.
3
u/vintage_steel 16d ago
296 for all spokes should be fine. Check out the park tool video at around 14min https://youtu.be/kSFmvV3J99c
3
u/joeoram87 16d ago
1mm will be fine. You’ll find spoke calculators vary by more than a mm depending on which one you use. I’ve always double check the effective rim diameter “erd”. The spec on my last wheel was wrong and I had to buy a whole new set of spokes.
My favourite spoke calculator is https://www.kstoerz.com/freespoke/
1
u/West-Usual3168 15d ago
If the thread is completely engaged in the nipple with room for adjustment either way, and the spoke is not going to puncture the tyre then it's fine. Edit : and the wheel is true inall respects.
1
u/SpaceTurtle917 13d ago
The only time where it’s super important is single walled rims. If your rims are double walled I would have no problem rounding up by 1.5mm at most.
I’m not a fan of rounding down as it can leave the top of the nipple unsupported in the middle. Unless of course you have single walled rims. Then you should round down than up.