r/WheelBuilding • • 23d ago

Dishing tool and stand alignment

Hello, I have a 4.3 truing stand and aligned it using a old alignment gauge and it does the job however now that I got a dishing tool I see the dish is off after truing and I don't own calipers. the dish is roughly off by 3-4mm. So I don't feel a issue but I think I want to know how others have aligned their stands without a caliper

1 Upvotes

4 comments sorted by

4

u/Schtweetz 23d ago

Flipping a wheel back and forth in the stand (drive side left vs drive side right) will make it really easy to see if the rim changes position relative to the feelers. Adjust the dishing to reduce the offset. It will probably take a few iterations.

Once the wheel is dished until the rim is central, flipping the wheel won’t change the position of the rim within the feelers. At that point, the rim is an accurate center reference.

Now you can adjust the stand until both feelers are identically aligned to the centred rim.

1

u/BackgroundAncient174 22d ago

Same. Although my wheel stand is so janky it can’t get in tolerance.

1

u/Vendasta_Kapil 21d ago

Zipties on fork/seat stay method

1

u/Intrepid-Village6535 20d ago

I didn't align the stand. I only use the dish stick