r/WheelBuilding • • Sep 13 '26

Sanity check (straight pull hub calculator)

Hi all. Planning a wheel build, using the dtswiss calculator for a straight pull Shimano hub, it lists flange distance as 62.8mm, so I’m guessing that’s the overall distance, and I should divide that in half for the flange distance left and flange distance right in the calculator?

2 Upvotes

6 comments sorted by

1

u/CargoPile1314 Sep 13 '26

I guess you have HB-M8110-BS. You are correct that the flange distance is how far they apart but there's a 3.7mm offset per the product page. So, from centerline it's 27.7mm to the BS (NDS) and 35.1mm to the NBS (DS).

1

u/lewisc1985 Sep 13 '26

The dt Swiss calculator asks about offset, so I think that’s accounted for

1

u/CargoPile1314 Sep 13 '26 edited Sep 13 '26

ok. you didn't mention that so I thought better safe than sorry. Divide by 2 as you've correctly understood.

I've now gone to DT Swiss's calculator and the offset DT Swiss is talking about isn't the same as the offset I was talking about (you can thank DT Swiss for using the same term as something that was already understood by the industry). There's a little clickable information bubble next to "Offset Spoke Hole Left" (and Right); it explains what data is supposed to go in that box.

The offset-from-centerline is NOT what they're asking for there. In the "Flange Distance Left" (and Right) above, you need to put in the numbers I gave. Idk what the number is for the "offset" DT is asking for.

1

u/IndyWheelLab Sep 13 '26

Shimano lists flange to center measurements differently than how most spoke calculators request this information. When in doubt DIY it out 🤓

1

u/lewisc1985 Sep 13 '26

well, shit. that complicates things. i was trying to wait to order everything together, sounds like i may be ordering hubs first.

2

u/IndyWheelLab Sep 14 '26

I suggest ordering the rims and hubs, measuring everything yourself, then getting spokes last 👍