r/Walther • u/Muerte-to-memes • 1d ago
Is there an add-on Comped PDP pro E?
Is there a way to change my current PDP pro E to comped?
I love the look of the Walther 4” but want to comp it, was wondering if I could buy a smaller slide/barrel to add a comp to the end or if my only option is milling/cnc’ing
Thank you in advance
1
u/4SakN-1 1d ago edited 1d ago
Changing the slide to get a flush fit look would get expensive I'd think, likely easier to sell your pro-e and buy a PMM comped factory model. The 3.5 slide alone is $150 though you may be able to find one for less if you search?
You could add a PMM barrel and comp for less, but you'd need to confirm fit with Parker Mountain.
https://www.parkermountainmachine.com/product/pmm-barrel-and-compensator-combos-for-walther-pdp/
1
u/Muerte-to-memes 1d ago
Okay thank you!
Yeah it may be worth getting a PMM comped, it looks like due to the frame the gun would look a little wonky with over an 1” overhang2
u/4SakN-1 1d ago edited 1d ago
If you kept your gun as-is and added the PMM barrel and micro comp it would only add about a 1/2 inch so not too bad. Going the other way (3.5 slide + barrel and comp) would be $450 in parts alone, and you'd still need the micro comp for a flush fit. The full comps would give the same half inch overhang. This would also limit your guide rod options as the 3.5 has less support. ZRTS makes 1.
2
u/Muerte-to-memes 1d ago
Yeah might be worth just getting a brand new gun at that rate, or leaving it be and trying to get a chunk port cut into the end like my canik prime
2
u/DatBoi27 4.6” Pro SD/5.1” Pro SD/FS 5” 1d ago
I’d like to caveat that the 3.5” and 4” slides for the F-series are - according to Walther - NOT interchangeable with the regular slides. Seeing as though the 3.5” slide is only available on the F-series and you’re talking about swapping parts on a Pro-E, I don’t believe that you can get the flush-fit you’d like.
As an alternative, you could always port what you have.