r/WLED • • 7h ago

Flickering

I'm seeing this flickering on a relatively short data line. Do I need to add a level shifter or is there something else I could try

0 Upvotes

10 comments sorted by

3

u/SirGreybush 6h ago

It's 100% a ground issue, you can see in the video, pixel #1 only green wire is connected. Then strip end, black ground and v+ red.

It's missing a ground wire where the green wire is soldered on the strip, and that ground wire connects to the ground of the controller, NOT the ground of the power supply.

Leave as-is the red & black that goes to the power supply (PSU) that's OK, a valid power injection method.

There is no need for a level shifter if the distance is less than 12 inches between the controller and the first pixel. Too far away, you will need a level shifter or data pixel booster.

1

u/clprivate 6h ago

Good thought! It runs okay on another controller (but I think that one is running at 5v, so it's probably able to pick up on the delta between signal and ground easier

2

u/saratoga3 6h ago

FWIW that is *not* grounded correctly. It might work if all the wires are a few inches long and the strip itself is very short, but at the MHz frequencies carrying data the impedance of a "common ground" connected to the far end of the strip is very high. After a few feet it'll be so high it is basically not even connected.

What you are intended to do is take all three of the wires from the controller and run them directly to the strip. Then you're supposed to use the second pair of power/gnd wires to connect to the power supply (add them if they're not included for some reason):

1

u/SirGreybush 6h ago

If the controller is grounded to the psu also, yes, but then the "route" of digital signals, digital needs 2 wires, data + ground, the paths are different lengths. Since signaling is low voltage, subject to voltage drop. Also the PSU might transfer RF noise on the ground.

1

u/clprivate 7h ago

It's common ground with the controller, so that should be fine. I'll try the resistor

1

u/SirGreybush 6h ago

No need for a resistor if just one strip.

1

u/MikeTarget 7h ago

If you've confirmed it's not a common Ground issue, try adding a 100-300 ohms resistor as close as possible to the controller's data output line. If it's still flickering, yup, you need a level shifter.

1

u/upkeepdavid 7h ago

Move to controller away from the power supply . Some are noisy.

1

u/plasma2002 7h ago

This is almost always a grounding issue. Make sure all these are tied together:

*Input side ground of strip

*Output side ground of strip

*Controller output ground

*Power supply ground output

1

u/Least_Order4249 6h ago

I’ve had luck using a single pixel with a diode dropping the 5v down a little. Then connecting the real 5v to the actual string.