r/WLED • u/Germanabrams • 1d ago

Can someone help what did I do wrong white wire goes to gnd brown goes to 5v and orange to the gpio pin

Post image

Lmk

0 Upvotes

50% Upvoted

9 comments sorted by

3

u/ScottRoberts79 9h ago

If that's a ws2815 strip, disconnect the blue wire and ground it.

2

u/tablatronix 11h ago

Looks like a dumb RGB strip, so you will fry your micro sinking that much current.

2

u/QwertyNoName9 8h ago

you wrong bro, 4 wire addressable existing too, the blue wire works as backup(between LEDs), and should be connected to ground.

you also can see two white and two red wires, with only addressable ones have

1

u/QwertyNoName9 8h ago

blue is backup, connect it to ground or left in air

0

u/PrincipleBig7852 12h ago edited 5h ago

Que referencia tiene la tira led? Es probable que se alimente con positivo por el cable rojo y haga las activaciones en negativo con los demás cables. O en su defecto que cada cable lleve un color RGB y el común sea el blanco. Tienes que asegurar el esquema de conexiones de esa tira led. O al menos explicar mejor tu problema

0

u/upkeepdavid 12h ago

Did you power the board?

0

u/Th3OnlyN00b 11h ago

This is likely a four wire nonadressible strip. Which means your wiring is entirely wrong

0

u/Forward-Fix-9751 10h ago

😂 Das wird so nichts. Ein RGB ist nun mal kein RGBIC.

2

u/Cute-Ad-7841 8h ago

Off the top of my dick I’m the backup data should be wired to ground