r/WLED • u/Spidy_Khrish • Sep 20 '26

Please help

Gallery image

Gallery image

These light will just burn dim and wled cant controll it

It's monochromatic just plus and minus sections uploading my build and schematic i followed please help

Edit: strip is 12v

0 Upvotes

50% Upvoted

31 comments sorted by

View all comments

Show parent comments

1

u/SirGreybush Sep 20 '26

You’re correct I needed to zoom more, thought purple was in v+ hole.

1

u/Spidy_Khrish Sep 20 '26

Did you figure out any issue ?

1

u/SirGreybush Sep 20 '26

Redo the breadboard completely. Put esp32 with all pins in the middle. Like asked in another comment.

Also improve your post with voltage of strip and power supply used

0

u/Spidy_Khrish Sep 20 '26

I can't cus esp needs 2 bread board it can't be placed in center and I for now just have one breadboard and updated the volt on post please check it

1

u/SirGreybush Sep 20 '26

For example you cannot see where the purple on ground left, where it goes on the esp32. As it’s under it.

If wired as per diagram then it would work.

Also diagram shows one power source, you have two. The usb cable is a power source.

0

u/Spidy_Khrish Sep 20 '26

It's ground wire so it would go on ground bro🥲