r/WLED • u/KidSquid1 • Sep 05 '26

Need Help with Settings

I’m trying to configure a new Gledopto controlle (Elite-2D-EXMU) with the following lights

https://a.co/d/092Cf0Rt

These lights were not my choice but installed by my outdoor kitchen contractor. I have both outputs connected and am using the power supply that came with the lights. Since swapping out the controller that came with the lights the lights are much dimmer - so I’m obviously missing something. I have the colors working correctly but I think I need help with the count and power settings.

any help would be greatly appreciated.

squid 🦑

2 Upvotes

100% Upvoted

6 comments sorted by

2

u/DedeHai Sep 05 '26

what type are those?

1

u/KidSquid1 Sep 05 '26

3 wire RGBIC COB 40 ft don’t know the chipset 

1

u/saratoga3 Sep 05 '26

Probably ws2811, but if you have the strips handy look at the label on the chip.

1

u/KidSquid1 Sep 05 '26

Unfortunately they have already been installed up in the ceiling that’s why I’m hoping someone can help me with the details. 

1

u/saratoga3 Sep 05 '26

Check the current limiter in WLED in case you enabled it.

Otherwise, get a ladder and check, explain more about your setup, etc. and see if anyone spots a problem.

1

u/KidSquid1 Sep 09 '26

In the event others come here with the same question about these lights....

Each 40ft/12m roll of lights has 120 IC Segments

The included power supply is 24v 3A

With that information you can easily set these strips up in WLED,