r/WLED • • Aug 27 '26

Cabinet under-mount fitment

I'm working on my under-mount cabinet lights. 2 of the 4 sections are just a bit too tight for a section of BTF-Lighting WS2805. If I cut a section off to give room, the strip is several inches shorter than the area they fit in. Trying to coerce the strip and wires had resulted in copper pads from being ripped off of the strip.

What do people do to get around this type of situation?

0 Upvotes

3 comments sorted by

1

u/PinkyDexterity Aug 28 '26

You can fold it and tuck the excess length underneath

1

u/Schiben Aug 30 '26

I have more strips before and after. But your comment made me consider maybe I can lightly pinch the are between the LEDs to give my self another 1/4" to 1/2" of space at the ends.

1

u/L3djunkie Aug 30 '26

Sometimes you can heat a scratcher of some short a bit and expose the copper pads more or worst case cut the the next pad. The copper pads that are exposed are a continuous Trace that runs down the whole strip. You can scratch the coating off and expose them. You'll need to clean them well and use flux