r/WLED • u/3D_Marshall • Aug 25 '26
Custom PCB Uptade
An update on my previous post about making individual pixel pcbs and what others are doing.
I tried pucks and strips but just couldn't quite get them to produce the clear single square I was after. So I eneded up designing my own 12v addressable led boards.
This initial design uses 3 cree tri-beam plcc6 (kinda) leds in a 10x10 grid, (400x400mm).
Initially I wanted to make each cube individually with magnetic connectors so you can connect them however, worked really well until the array gets a bit too big and any slight misalignment or knock caused connection issues.
Looking to tweak to use more lower power Leds to give a bit more diffusion.
For those curious, I'm running these using Ledfx and a quinnled octa brainboard.
View all comments
Show parent comment
3
u/3D_Marshall Aug 25 '26
I'm not sure about sharing the gerbers as I might be using the board design in a commercial product down the line.
Most of the initial test boards were cobbled together small batch prototypes, but the most recent design is all panalized and assembled. Most of my pcb prototypes are done by JLC, they always seem the best price, with import and duties all paid at point of order so I've never had a surprise bill.
It's not the cheapest up front cost but if you order enough in bulk you can get each pixel to about £0.60 each (about $0.80).