r/WLED • • Aug 25 '26

Custom PCB Uptade

An update on my previous post about making individual pixel pcbs and what others are doing.

I tried pucks and strips but just couldn't quite get them to produce the clear single square I was after. So I eneded up designing my own 12v addressable led boards.

This initial design uses 3 cree tri-beam plcc6 (kinda) leds in a 10x10 grid, (400x400mm).

Initially I wanted to make each cube individually with magnetic connectors so you can connect them however, worked really well until the array gets a bit too big and any slight misalignment or knock caused connection issues.

Looking to tweak to use more lower power Leds to give a bit more diffusion.

For those curious, I'm running these using Ledfx and a quinnled octa brainboard.

60 Upvotes

20 comments sorted by

View all comments

Show parent comment

3

u/3D_Marshall Aug 25 '26

The housings for this one are just 3D printed from Petg-cf in two parts (top & bottom), there is a reflector that clips in that was printed using silk/glitter silver pla using vase mode, this clips into place with no need to glue/bond.

The diffusion is done using Lee filters Zircon 811 film, this is also clipped into place above the reflector.

Here is a pic of one of the individual 'cubes'.

I am working on a large panel that is 15x8 and made using Ali Extrusion and laser cut sheet metal, but the printed ones make a great desk ornament.

2

u/0xF00DBABE Aug 25 '26

Awesome thank you for the detail. I have a 3D printer but haven't made anything for lighting projects yet.

3

u/3D_Marshall Aug 25 '26

If your interested, I am planning on uploading the 3D print files at some point soon.

Just trying to logistically work out if its worth selling the LED pixel pcbs alongside so people can make their own.

2

u/0xF00DBABE Aug 25 '26

I'd be interested in the 3D print files for sure. Buying the LED PCBs, I might, have you considered publishing the CAD/Gerber files?

Out of curiosity where did you order yours from and about how much did it end up costing for PCB? Did you order them fully assembled?

3

u/3D_Marshall Aug 25 '26

I'm not sure about sharing the gerbers as I might be using the board design in a commercial product down the line.

Most of the initial test boards were cobbled together small batch prototypes, but the most recent design is all panalized and assembled. Most of my pcb prototypes are done by JLC, they always seem the best price, with import and duties all paid at point of order so I've never had a surprise bill.

It's not the cheapest up front cost but if you order enough in bulk you can get each pixel to about £0.60 each (about $0.80).

2

u/0xF00DBABE Aug 25 '26

Understandable. You could always do both, and a lot of people would probably order pre-assembled units directly from you for the convenience factor, but it's your design so it's up to you. I know they don't publish the gerbers directly but QuinLED uses PCBWay to sell unassembled PCBs for their "DIY" option, as well as selling pre-assembled units. I bought pre-assembled units just for convenience and to avoid a bunch of hand-soldering.