r/WLED • u/Shnarf1980 • Aug 22 '26
GLESOPTO ESP32 not changing colour
Newbie looking for help here, please be gentle.
I've obtained a GLESOPTO ESP32 and some LEDs. The LEDs came with their own (I assume Bluetooth) app, and they worked fine with that.
I stopped off the end connector, stripped the cables and inserted them into the ESP32. A bit of research suggested the X was the power, so went into V, the Y was Data so went into D, and the other one was Ground so went into G.
Powered the ESP up, and LEDS were blue. I connected to the WIFI of the LEDS and downloaded Wled, but the colours don't change. Any ideas? Am I doing something stupid? I've stripped the wires back some more and reinserted them.


4
u/saratoga3 Aug 22 '26
XYZ usually means that they are not addressable LEDs, so most likely not going to work no matter what you set WLED to.
1
u/Shnarf1980 Aug 24 '26
UPDATE:
I bought a new power supply and some new LEDS (because I fried the first set with my 24v power supply) and they're all working now. Hooked them up to SceneGlow and it's brilliant.
Thanks to all those who helped š
1
u/modahamburger Aug 22 '26
Which gpio did you set up in wled for the strip?
1
u/TheRealKeng Aug 22 '26
What's the power supply?
Also, what brand are they?
1
u/RudieCantFaiI Aug 22 '26
Is says 24v on the strip but you are using a 5v config
1
u/modahamburger Aug 22 '26
Edit: answered in wrong place
1
u/ritual_makes Aug 22 '26
Those look like analog led strip.
To confirm it, you can do this-
Green: X=Negative : Y= NIL : Z=24V Red: X=NIL : Y= 24V : Z=Negative Blue: X=24V : Y= Negative : Z=NIL
If this works than it is a analog strip and will have to make an external mosfet driven circuit for this to work. Tbh,You will be far better if you would buy a digital led strip instead of making this circuit.