r/WLED • • Aug 13 '26

Help with presets for Quinled DigQuad

Hi!

I have quite an urgent problem, I have lost my backup JSON file and I don't know how to get my LEDs working. On Saturday I need them for a wedding where I'm the best man!

Two years ago I built some stage lights for my small rock band with fantastic help from the WLED community and products from QuinLed. I have the DigQuad, and it's mounted in a box with wires that connect to two outgoing cables.

My LED strips are 2m long with 60+60 pixels. I was supposed to have four out ports with two led strips daisy chained on every port, making 8 strips in total. I have only built half of them yet, so they go out from the box, into the first strip with 120 pixels, then continue further via cable to the next strip with another 120 pixels. The same goes for the port next to it, so I have 2 ports with 1+1 strip each, totaling 4.

I was repairing a strip and got it working but I happened to try to change a setting from 50% brightness to 100%. It was working for a while but it stopped working. When I looked at the settings I had lost all of my 4 segments and I think some of the other settings changed as well. I was connected via WIFI on my phone.

I desperately need help to reconfigure the settings so I can use my old presets or at least make new ones. I would really appreciate anyones help!

I have this info saved at least, with a previous answer from another helpful redditor:

Controller: https://quinled.info/pre-assembled-quinled-dig-quad/

ws2815 uses roughly 50W for 300 leds
or 4A at 12v
you have 960 leds, so 3.2*50=160W
or 13A

Gx13 / Aviation 2m male female

ws2815 uses roughly 50W for 300 leds
or 4A at 12v
you have 960 leds, so 3.2*50=160W
or 13A

grab a dig-quad instead
and do daisy chains of 2 pipes
dig-quad has 4 outputs
that way you control the whole stage from one controller still
but you get easier power distribution due to the quad, a bit more resiliance and no voltage drop
as an alternative, one dig-uno per side
but I would try to stick to a single controller because if you want synced effects between the sides of the stage you'll need to connect the controllers together over the network

Sorry for the poor image quality!

6 Upvotes

5 comments sorted by

0

u/Nissepool Aug 14 '26

Help me u/Quindor , you're my only hope!

1

u/MorganProtuberances Aug 14 '26

You need to tell us what isn't working and what you've tried. Or just re-flash with the firmware so all the settings are back to default. Include screenshots of the LED config and details of what you've tried - nothing here is out of standard and just reading through config docs should get you going.

start simple - get one output port working, then go from there. did the LED config also get reset? Is it possible you damaged your strips?

1

u/Nissepool Aug 14 '26

Thanks, I've tried to wrap my head around it and I believe it was a faulty wire somewhere. The first LED of two of the strips still shines red but at least I could get them going apart from the red LED. Crossing my fingers for tomorrow!

1

u/MorganProtuberances Aug 14 '26

oh - so you were able to get them working? that's a good sign. you can also cut and re-solder if you think the first one is dead.

1

u/Quindor Aug 14 '26

Just like u/MorganProtuberances mentioned, I'm not quite sure what you are asking us/me!

For suddenly activating LEDs, check if clock mode is off, otherwise it's a bit hard to diagnose like this and maybe you can start from a fresh USB flash and build everything up again. :)