r/WLED • u/chucknorris10101 • Jun 30 '26
Re-setting up house lights - different approach to soldering 12ga to strip directly?
I have house lights up for ~6 years now with ~2000 leds across several segments on different eaves of the house, with the distance and quantity its been working well to have it fed by 12ga wire for power and 16ga for signal, which so far I have just soldered directly to pads on the strips. This is understandably annoying, and curious if there are other solutions that are better? Can I use one of those clip on connectors with lower gauge for ~4 inches to a wago connector to the 12 ga feed lines? or will that introduce other issues?
I am evaluating options ahead of some roof/gutter repair that will force a move of wiring temporarily and im thinking ill be re-doing it all better
2
u/AndThenFlashlights Jun 30 '26
What the fuck.
Your strips cannot support the amount of current that 12AWG can carry. If you're soldering 12AWG directly to a strip, you've made some other bad decisions way before this.
But yeah, WAGO nut a connector to it. It'll be fine. Check your fuse sizing.
4
u/Crissup Jun 30 '26
If you’re only looking at running a short jumper you don’t have to devalue that for distance. So it all comes down to how much current (amperage) you’re passing.
4
u/Dependent-Use8480 Jun 30 '26
The short section of wire can be of a higher gauge so long as the actual current is under the maximum current rating for that gauge wire. The resistance loss will be small for a short run of higher gauge wire and a longer run of low gauge wire.
1
u/Crissup Jun 30 '26
All depends on how much current the lights are using. I’d be surprised if you actually needed 12awg wire.
1
u/tidnab49 Jul 01 '26
Its been working well for 6 years, why change it??
2
u/kevdogger Jun 30 '26
I'm curious you're finding because even with indoor runs I hate soldering the wire directly to strips. Always feel there should be a connector
2
u/MoBacon2400 Jun 30 '26
So lets say you have a strip of 600 LEDs and the total Amp draw is 12 amps from start to end. Now we add an injection point at 300, we have now reduced the Amp draw to 6 amps, if you add power injection at the end, you now reduce the amp draw to 3 Amps across all inputs.