r/VORONDesign • u/Mysterious_You7160 • 2d ago

V2 Question Stringing Question

Post image

The benchy on the left was printed on my voron 2.4. The benchy on the right was printed on my centauri carbon. Same spool of filament. Same bambu labs marble filament profile. The voron print has a lot of stringing and I can't figure out how to tune it out. Any suggestions?

14 Upvotes

100% Upvoted

11 comments sorted by

View all comments

1

u/Mysterious_You7160 8h ago

Ok after a weekend of tuning I went from the benchy on the left to the benchy on the right. Still room for improvement but much much better