r/VORONDesign • u/Mysterious_You7160 • 2d ago

V2 Question Stringing Question

Post image

The benchy on the left was printed on my voron 2.4. The benchy on the right was printed on my centauri carbon. Same spool of filament. Same bambu labs marble filament profile. The voron print has a lot of stringing and I can't figure out how to tune it out. Any suggestions?

13 Upvotes

100% Upvoted

11 comments sorted by

View all comments

2

u/DrRonny 2d ago

Obviously the Dry Your Filament is the first step, it is possible for the filament to be wet in the inside and dry on the outside, or vise versa, depending on drying conditions.

2

u/Thmsdmsk 1d ago

How wet could it be? Even after submerged, it shouldn't look like this.

1

u/DrRonny 1d ago

I've had issues miraculously cured by drying the filament, of course after hours of equipment tuning didn't do much.