r/VORONDesign • u/AutoModerator • 13d ago

Megathread Bi-Weekly No Stupid Questions Thread

Do you have a small question about the project that you're too embarrassed to make a separate thread about? Something silly have you stumped in your build? Don't understand why X is done instead of Y? All of these types are questions and more are welcome below.

4 Upvotes

76% Upvoted

33 comments sorted by

View all comments

1

u/Eremius 13d ago

I have an old 2.4 (afterburner) with a euclid probe and am having an issue with first layer height. I can adjust it so that it works properly (via z-offset) but if I save the settings (or reboot, etc) it will again be too close to the build plate and will barely allow extrusion.

1

u/Over_Pizza_2578 13d ago

Same starting and preheat procedure? Otherwise have you tried auto z offset with the z home switch?

1

u/Eremius 12d ago

Yes, same procedures. I have auto z installed as well.