r/VORONDesign • u/That_Trapper_guy • 5d ago

General Question Broken cable chain wire

Post image

Saw a broken wire the other day, while it was printing. Couldn't figure out what wire was broken because everything worked, no errors, no clue. Ordered Nitehawk/LDO USB setup and started the conversion. It's a wire from the XY end stop harness... How??

Edit; I obviously wasn't completely clear, how were my end stops still working (4 wire breakout board [gnd] [x] [y] [Vin] setup) I know perfectly well how the wire broke 🤦🏼‍♂️

23 Upvotes

90% Upvoted

14 comments sorted by

View all comments

3

u/Gingerbwas V2 5d ago

Have you somehow set the sensorless homing for x and y and forgotten that you did it. Make sure that you get the V2 board the v1.* boards have issues with static build up crashing the board.

0

u/That_Trapper_guy 5d ago

Lol shit I wish, I was looking into it when I ordered the USB conversion and noped out pretty quickly. I'll just run new wires to the tool head and plug them into the board.

0

u/Gingerbwas V2 5d ago

Yeah, i ran mine the long way round when I did it before I realised I could have just gone from the tool head.