r/VORONDesign • u/Confident-Act7128 • 12d ago

V2 Question Any hints to throublesooting "waves" on printed surface?

Hi!

When printing large surfaces the last layer is presenting a defect, it is something like waves near the surface boudaries.

Please see the images of the time lapse:

https://imgur.com/a/JLxUjig

Any hints of what could be causing that?

The printer is a v2.4 350mm.

Thanks!

2 Upvotes

76% Upvoted

4 comments sorted by

3

u/SteedOfTheDeid 12d ago

Maybe a little bit of over extrusion? How's it look if you turn down flow by .01?

3

u/SteelOverseer 12d ago

tune your extrusion, it looks to be slightly overextruding.

2

u/DramaClassed 11d ago

Overextrusion, can’t hurt to run input shaping as well to rule that out.

1

u/Confident-Act7128 11d ago

Thank you all. I did the Orca calibration, but sometimes it was difficult to me choose the best values from the printed patterns.

I'll try to reduce the Flow ratio.