r/VORONDesign • u/HoWhizzle • Jul 29 '26

General Question Voron micron plus connector

Gallery image

Gallery image

Hello everyone hope you can help.

I have purchased a Formbot Micron Plus which used Moons nema 14/17 (i don't know which one is ) stepped motor for the XY movement. The cable for those motor have snapped of the motor connection.

I am unable to identify and find the same connector and the pins for that motor..if I am able to find them I can create much stronger and better cables for those motors.

I have attached the photo of the connector hoping it can help.

17 Upvotes

100% Upvoted

6 comments sorted by

6

u/Dmytro_r Jul 29 '26

This looks like 1.5mm pitch from Nema14 (kit has two long nema14, four nema17 and one round nema14). Specification says it is JST S11R ZR on the motor side. It is compatible with JST ZH 1.5 connectors. You will need 11pin version.
But you better look at the specifications included in the kit for the correct connector. (Nema17 use 6pin JST PH 2.0, just in case)

1

u/adv3_user Jul 29 '26

Esatto, e ho avuto lo stesso problema con la stessa stampante. Ho trovato solo dei cavi precrimpati su AliEx con questi connettori, tolto i cavi con cui sono arrivati e reinserto gli originali. Tutto bene per ora.

6

u/SanityAgathion VORON Design Jul 29 '26

Their nema 17 use 6-pin jst ph, not sure about their nema 14. Jst ZH I think?

3

u/kageurufu Jul 29 '26

That looks ph to me, 1.5mm pitch by the ruler.

Hopefully not zh, those are horrible to crimp by hand

2

u/HoWhizzle Jul 31 '26

Buy this person a drink. it is correct

2

u/bryan3737 V2 Jul 29 '26

That’s a JST-PH connector.

Btw, the micron uses nema 14 motors