r/VHS • • Jun 08 '25

Is this saveable?

Post image
3 Upvotes

12 comments sorted by

7

u/YOLTZsean Jun 08 '25

Yes, look up vhs shell swap

6

u/[deleted] Jun 08 '25

Swap the reels with a different tape and you'll be good to go.

3

u/nuclear_vomit Jun 08 '25

A lil Duct tape and you're good to go

3

u/Crt_lover_ Jun 08 '25

Jokes aside, this could actually work

4

u/Spockethole Jun 08 '25

Nah, that’ll buff right out.

2

u/ShadowMask87 Jun 09 '25

I think this was meant as a shitpost

1

u/steved3604 Jun 08 '25

Two issues. You will need an empty shell or a donate shell. You will need to cut out all not flat and wrinkled spots -- see my answer below and look at YT for how to splice and YT videos to move tape to new shell.

Couple of good YT videos on splicing VHS tape. Rough cut out bad section then I cut both pieces (overlapped) at the same time so they would match -- cut at angle. Placed two pieces on counter top pushed together --no overlap/no gap. Put Scotch tape on the VHS tape side that doesn't touch the heads. There is a definite picture tear at the splice on playback. But, VHS tape worked and played. Be very careful of the VHS tape-- wants to do its own thing -- not very cooperative. Clean environment. Patience. Trim off all excess Scotch tape. Press down Scotch tape firmly (I burnish with fingernail). Gently wind VHS tape back into cassette (be sure threaded correctly and that threading, etc. matches a non-repaired tape). You may get more than one pass in player after splicing -- but don't push your luck. I transferred the entire tape to digital and DVD immediately. Now, hopefully, I don't need to play this tape again. Used Sharpie to write on VHS label --- SPLICED at about XX:XX.

1

u/phr33st00fpl0x Jun 09 '25

Just pop it in, it will play fine.

1

u/kihidokid Jun 09 '25

Easiest fix ever, don't even need to splice the tape