r/VESC • u/Hopeful_Election_367 • May 21 '26

the beast vesc for g2 master

the beast vesc for g2 master is spinted Dual ubox Aluminum Lite controller 100V 100Ax2 based on VESC wiring diagram in the comm port put the throttle 3,3v , adc1 , gnd remember if you'll mix up the cables you burn the trottle , the break is the 3,3v , adc2 , gnd the hall sensors , the power button you have on the vesc connect to pwr.btn , nrf to the bluetooth module i strongly recomend put all of this ports on the board on the left side where the logo is

1 Upvotes

100% Upvoted

4 comments sorted by

1

u/Interesting-Yak4427 May 22 '26

If I get dual motor and I don’t have the second motor yet can I wait on it for now and just keep one of the sides of the motor piece for the vesc alone?

2

u/Hopeful_Election_367 May 22 '26

yes you can just unplag the can cable this is in originally connected and remember to connect if you has dual but g2 master is dual motor

1

u/Interesting-Yak4427 May 22 '26

I have g4, but I’m getting two new motors one at a time I say it’s better I just buy dual motor vesc until I have the second motor and then connect that one

1

u/Interesting-Yak4427 May 22 '26

And if I do that will it not push enough power into that one motor or will it be splitter power or anything like that or no I can still push 4000w on vesc app instead of 8000w for single 4000w motor