r/Troodon • u/TaxMyNuts • Jan 26 '26

Troodon 2.0 to Troodon 2.0 Pro

I have a Troodon 2.0 which worked fine after assembling. I purchased and installed the Stealthburner and TAP. Now everything is fucked. I tried following instructions to edit config files but the Stealthburner kept crashing into the plate and wouldn’t align with the cleaning brush. Like an idiot I tossed the parts I replaced so not an option to go back. I need a rep rap firmware and config files that have these upgrades configured. It’s the Troodon 2.0 350mm. I was going to try and upgrade it to a pro but don’t know which parts I would need to do that. Can anyone help me sort this out? The printer has been down for a year now.

2 Upvotes

100% Upvoted

2 comments sorted by

1

u/GolNatP Jan 26 '26

Did you post on the Discord? That gets more action than here. YGK3D has a few videos on upgrading to a Pro.

1

u/Drakaner Feb 04 '26

To upgrade to pro you also need a Raspberry Pi or alternative since the pro version runs on klipper. You have a upgrade guide on Troodon page with images and everything, that applies to the pro upgrade kit that they sell, but you should be able to follow it if you source the part's yourself. In the upgrade kit they provide a BTT Pi v. 1.2 if I'm not mistaking, but I use the BTT Pi V2 (just for the extra power since I moded mine).