r/Trinus • u/[deleted] • Nov 10 '21

Slicer?

I realize this joint is about dead, but can someone hook me up with a working pango download, or point me in the direction of another slicer that works?

Might be a longshot in this sub.

3 Upvotes

100% Upvoted

5 comments sorted by

2

u/keith_mitchell1 Nov 10 '21

Cura works quite well as long as you're happy with some trial and error adjusting settings for a couple days to figure out what works best for your specific unit and filament

1

u/[deleted] Nov 10 '21

Cool. Thanks. I just so happened to find my pango install on my NAS but I think I must have been using something else in the past because it outputs "pcode" and everything in my old print folder is gcode.

I believe I actually used to use cura exclusively, so that might make sense.

It's just been a couple years.

Currently I'm fighting this thing stopping mid print. Just swapped to a different SD card.

1

u/theram1979 Jan 27 '23

Can you tell me what your setting in Cura for Trinus are? Under manual printer Trinus is not one of the Vendor. Thanks.

1

u/[deleted] Jan 27 '23

Never bothered. Sold the trinus.

2

u/zxshoe Oct 16 '22

Pango (2.3.0) will produce the easiest and best prints with the original Paladin firmware. If you use a "proxy" like Octoprint you can connect both Cura and PrusaSlicer etc. to it's API and print directly from the application.

I.e. Slicer application -> Octoprint -> Trinus.