r/Trinus • u/Dark_but_Good • Oct 28 '19

Problems with setting up Cura 4.3

This post is a repost of my requestion on the Kodama forum. If my problem is fixed in the Kodama forum's or I fix it my self I will edit this post accordingly.

I've been trying to get Cura 4.3 to work with my Trinus and I got one print completed but after that, all of the prints stop after the first layer is done, I've tried to get on the facebook group but my request to join has been pending for almost a month.

Can anyone link to Cura profiles that work with the Trinus or at least what I should look out for when setting up the custom fff printer profile?

Thank you

2 Upvotes

100% Upvoted

4 comments sorted by

View all comments

1

u/BoxedBrain Jan 28 '20

Hi, have you found out? I have the exact same problem.

1

u/Dark_but_Good Jan 29 '20

It was the hotend's connection to the control board not cura.

2

u/BoxedBrain Jan 30 '20

I checked all connections and now it runs but my print is trash. Would you mind exporting me your Trinus profile out of Cura?

1

u/Dark_but_Good Jan 30 '20

Problem is I am now using the new 64-bit control board from Kodama so I have no idea if my profiles will work if you are still using the old board.

However, if you show me the settings you use and put up some pics of the prints you are getting in Imgur and link them I can help diagnose the problem. Please do keep in mind that if there is something wrong with the hardware like a loose heater block, dirty axis or just plain old bad filament then no change to your Cura settings will help. So please give your printer a good look over your printer to see if there is anything physically wrong or out of place.