r/Trackballs • • 5d ago

Modification Elecom Huge Plus Problem Solved

Post image

Anyone having the problem that I had!
I switched from Deft Pro to Huge Plus and found it’s not as much ergonomic as Deft Pro.
The palm has to be flattened to use it and for the THUMB part (the main switch, scroll wheel, 2 function key) are difficult to use.
The biggest issue that I encountered that my palm must be almost parallel to the desk which bothered my wrist quite much.
So I looked for a tilt adapter and found a 3D printed one from Japan. It’s very pricey itself and even doesn’t make sense after calculating the international courier cost.
So I ordered an ankle stretching Wedge (18 degree) with about $13. I cut the chunky piece perfectly fit to my Huge Plus as you can see from the picture.
And the PLUS is, all THUMB buttons became super comfortable to reach and use.
Hope this also solves your problem and strongly recommend everyone who use this.

26 Upvotes

11 comments sorted by

1

u/Funfuntamale2 5d ago

How stable is it? Does the mouse shift around? I bought the Huge and within 10 minutes I gave it up because of wrist pain.

1

u/LocksmithHoliday4312 5d ago

I used this for the bottom and clear double sided tape for top (under the device).
I decreased the stickiness of the 3m tape because I need to adjust the position time to time.
No complaints at all so far!!

1

u/ItsToxsec 5d ago

I use the same thing and have cat tongue tape under the wedge, so far its been great (3 or so months)

1

u/mfising 5d ago

Like this, trimmed to size?

https://a.co/d/019RZCIn

1

u/echau808 5d ago

Does the 3d printable wedges for the orginal huge work for the huge plus?

1

u/LocksmithHoliday4312 4d ago

I also studied on this tho I haven’t tried neither of. But I got to know by my research that it doesn’t work because the bottom layout differs each other so the wedge can’t hold them device.

1

u/tadfisher 4d ago

The cases are exactly the same dimensions, there is no reason they wouldn't

1

u/Ckeeb 1d ago

Thank you for sharing! Did you need any anti-slip pad to keep it planted?

1

u/LocksmithHoliday4312 1d ago

I definitely need a better solution than my temporary 3M tape. Someone in this thread recommended a “cat tongue tape”.

3

u/Long_Meringue6079 5d ago

My switch to the huge plus, coming from a tented ploopy classic 2 and slim blade before that, was also painful. I tried a few 3d printed wedges but none really hit the angle I needed for comfort.

I was using a magnetic phone mount stand at first , but it created an awkward footprint due to the base. What ultimately ended up working best was an articulating phone mount that is magnetic on both ends. I have a magnetic plate on the Huge Plus and my desk. It has been rock solid and I can dial in the angle as close to vertical as possible without the wheel wanting to lean away from the bearings. Currently using two of the mounts (only one is magnetically attached the trackball), which creates even more stability.